Friday, October 9, 2009

Two-Colour Infant Hat




I made this set for twins whose parents are Harry Potter fans. You can use the Hogwarts house colours, as I have, or any two contrasting colours. There are notes at the end for making a larger size.

Size: 3 months; circumference of 40cm (16in)

Yarn: 1 skein Patons Astra (50g, 147m per skein) in each of two colours, or other DK weight yarn.
For the hats shown in the photographs, I used the following combinations of Patons Astra for colours A and B: Cardinal (02762) and School Bus Yellow (02941); Dark Denim (02777) and Silver Grey Mix (02729); Black (02765) and School Bus Yellow (02941); Forest (02881) and Silver Grey Mix (02729).

Gauge: 22 stitches and 28 rows over 10cm (4in) square using larger needles.

Needles: 3.25 and 4mm (set of 4 double-pointed needles or 2 circular needles) or size to achieve gauge.

Abbreviations:
K: knit
K2tog: knit 2 together
M1: make one new stitch by picking up, twisting and knitting through bar on previous row

Instructions for Hat:

With colour A and smaller needles, cast on 76 stitches. Join in a round, making sure the row is not twisted and do 10 rounds of 2x2 rib (K2, P2 around).

Change to larger needles. Join colour B and begin fair-isle pattern starting with first round at the bottom of the following chart. In the first round, which is all in colour B, increase 12 stitches as follows: (K6, M1, K6, M1, K7, M1) 4 times. (88 stitches)



Work chart from bottom to top, repeating the 8-stitch pattern to the end of each round. Note that white squares are done in the main colour A and grey squares are done in the contrasting colour B.

Break off colour B and work remainder of hat in colour A. Start decreasing for crown.
First round: (K9, K2tog) 8 times. (80 stitches)
Next round: (K8, K2tog) 8 times. (72 stitches)
Next round: (K7, K2tog) 8 times. (64 stitches)
Next round: (K6, K2tog) 8 times. (56 stitches)
Next round: (K5, K2tog) 8 times. (48 stitches)
Next round: (K4, K2tog) 8 times. (40 stitches)
Next round: (K3, K2tog) 8 times. (32 stitches)
Next round: (K2, K2tog) 8 times. (24 stitches)
Next round: (K1, K2tog) 8 times. (16 stitches)
Next round: K2tog 8 times. (8 stitches)

Draw yarn through all 8 remaining stitches and close tight. Secure yarn in a knot. Weave in ends.


Notes on making a larger size:

Unfortunately, I don't have time right now to work out other sizes. However, I've included some notes below to help you adjust the pattern on your own.

I made this in a child/youth size as follows. Cast on 96 stitches. Do 11 rows of 2x2 ribbing. Increase 16 stitches to 112 stitches on first row by repeating (K6, M1) to end. Do fair-isle pattern, repeating a couple of the narrow bands to increase the height of the hat. Work crown as above except start with (K12, K2tog) on first decrease row, (K11, K2tog) on second, etc. If you don't want to do all the crown shaping in one colour (which leaves a largish area in that colour at the top of the hat), improvise and add in a yellow band, but take care to work the decreases into the pattern. Alternatively, you can add a pompom in the contrasting colour.

You can also increase the size by using a thicker yarn and correspondingly larger needle size.

3 comments:

Caitriona said...

This pattern is lovely and exactly what I have been looking for! Thanks for sharing. I'm going to cast on right away.

ELENA said...

Lindo gorro!!

Donna said...

Wonderful! Thank you! Just what I was looking for!!